The short answer: a microwave drawer is the better design in a remodel with a real range hood; an over-the-range (OTR) microwave is the better value everywhere else. Drawers sit below the counter, so nobody lifts hot food overhead, and they leave room for a proper hood. But they cost $1,200 to $2,250, top out at 1.2 cu ft and 950 W, and need a cabinet cutout. OTRs cost $230 to $700, hold up to 2.1 cu ft, vent the cooktop and fit the standard 30-inch gap above a range.

Prices checked November 19, 2026. Maker-site prices unless noted.

Drawer vs. OTR at a Glance

Microwave drawerOver-the-range microwave
LocationLower cabinet or island, under the counterUnder upper cabinets, above the range
Capacity1.2 cu ft (1.4 cu ft convection drawer)Mostly 1.6–2.1 cu ft
Microwave power950 W (900 W convection drawer)950–1,100 W
VentingNone; needs a separate hoodBuilt-in fan, 220–400 CFM on most
Width24 or 30 in30 in
ReachWaist height, pull-outAbove the cooktop
Island installYesNo (GE, Samsung and LG prohibit it)
Price$1,199.99–$2,249About $230–$700 mainstream

Prices and Specs

ModelTypeWidthCapacityPowerVent / sensorPrice (Nov 19)
Sharp SMD2470ASYDrawer24 in1.2 cu ft950 WSensor$1,497.00 on Amazon; $1,499.99 at Sharp
Sharp SMD3070ASYDrawer30 in1.2 cu ft950 W—$1,597.00 on Amazon; $1,599.99 at Sharp
Sharp SMD2499FSConvection drawer24 in1.4 cu ft900 WSensor$2,499.99 at Sharp
Bosch HMD8054UCDrawer30 in1.2 cu ft950 WAuto programs$2,249 at Bosch
Bosch HMD8454UCDrawer24 in1.2 cu ft950 WAuto programs$2,149 at Bosch
GE JVM3160RFSSOTR30 in1.6 cu ft1,000 W300 CFM, no sensor$227.00 on Amazon
GE Profile PVM9005SJSSOTR30 in2.1 cu ft1,050 W400 CFM, sensor$399 at GE (was $719)
LG MVEL2125XOTR30 in2.1 cu ft1,050 W400 CFM, sensor$469 at LG
Samsung ME21DG6300SRAAOTR30 in2.1 cu ft1,000 W400 CFM, sensor$459 at Samsung

The cheapest drawer in Sharp’s lineup (SMD2420MS) was $1,199.99. The cheapest OTR here is about a fifth of that.

Capacity and What Fits

Every drawer listed is 1.2 cu ft, except Sharp’s 1.4 cu ft convection model. That holds a dinner plate or a covered bowl, and the drawer’s top-down access makes it easy to set a heavy dish in. OTRs reach 2.1 cu ft and take larger casseroles. If you microwave big batches, an OTR or a large countertop model holds more.

Venting

A drawer doesn’t vent anything, so the range needs a hood. That’s the upside as well as the cost: a full-depth hood covers the front burners better than an OTR’s shallow fan. If your kitchen already has a good hood, a drawer is the natural fit; if not, the hood is an added cost of going the drawer route. More on fans in recirculating vs. ducted venting.

Installation

Drawers go in a lower cabinet or island. Sharp’s SMD2470ASY needs a standard cutout of 22-1/8 W × 15-9/16 H × 23-1/2 D inches (flush mount 24-3/16 × 16-7/8 × 23-1/2). The convection SMD2499FS needs a taller 19-3/8-inch opening. Sharp’s install manual calls for a 120 V, 15 A or greater supply (a separate circuit is recommended), a floor that supports 100 lb, and allows installation below a wall oven with at least 2 inches between them.

OTRs need a 30-inch gap between upper cabinets and a dedicated outlet in the cabinet above. GE and Frigidaire specify 66 inches or more from the floor to the top of the microwave, and at least 30 inches from the cooktop to the bottom of the upper cabinet. Replacing an existing OTR is a two-person DIY job; see OTR installation.

Reach and Safety

This is where drawers win. An OTR’s bottom edge sits above the cooktop, often near eye level, so you lift hot liquids over burners. A drawer opens at waist height: you look down into it, and Sharp’s drawers open with a touch control. For shorter cooks, wheelchair users and kids, that’s a real difference.

Made in the USA

Sharp says its microwave drawers are “proudly assembled in Memphis, Tennessee,” and the SMD2499FS spec sheet says “Assembled in USA from imported and domestic parts.” No OTR maker states US assembly for its microwaves.

Best 24-Inch microwave drawer

Sharp SMD2470ASY

24-inch, 1.2 cu ft, 950 W microwave drawer with sensor cooking; sold by Amazon.

Lowest-Cost OTR

GE JVM3160RFSS

1.6 cu ft, 1,000 W over-the-range microwave with a 300 CFM 2-speed fan.

Which Should You Buy?

FAQ

Is a microwave drawer better than an over-the-range microwave?

It’s easier and safer to use, since it opens at waist height, and it lets you install a better range hood. An OTR is cheaper, holds more (up to 2.1 cu ft vs. 1.2) and vents the cooktop by itself.

How much does a microwave drawer cost?

On November 19, 2026, Sharp’s drawers ran $1,199.99 to $2,499.99 on Sharp’s site, and Bosch’s were $2,149 to $2,249. Sharp’s SMD2470ASY was $1,497 on Amazon.

Do microwave drawers need special wiring?

They need a 120 V outlet in the cabinet. Sharp’s manual calls for a 15 A or greater supply and recommends a separate circuit.

Can you put a microwave drawer in an island?

Yes. Sharp’s drawers are designed for under-counter, island and peninsula installation. OTR makers including GE, Samsung and LG prohibit island or peninsula mounting.

Are microwave drawers made in the USA?

Sharp says its microwave drawers are assembled in Memphis, Tennessee, from imported and domestic parts.

Sources